Yes. True Microcurrent uses less than 1000 microamperes and because of it's low intensity, it typically is sub-sensory and cannot cause a physical or visual manipulation (contraction) of the muscle via the electrical current. When using the MyoLift or MyoLift 600, as long as the conductivity bar is solid, the current is flowing.

All of our devices are FDA cleared and give you the power of “True Microcurrent”

The MyoLift Mini has two waveforms, one for tightening the muscle (Educate) and one for relaxing or lengthening the muscle (Erase).

The serial number is located on the back of your MyoLift device.

EDUCATE (Shortens the muscles): This program helps you re-educate facial muscles. You will use this program in the areas where your muscles need to either get shorter or lifted, like cheekbones, eyebrows, nasolabial folds, and jowls, etc. There are two different levels. Start with Level 1 for 15-20 days before switching to Level 2 to get deeper rooted muscles toned. Entire face can be conducted.

ERASE (Lengthen the muscles): This program works to help erase fine lines. You will use this program in areas where you need to lengthen the facial muscles or remove wrinkles. Start with Level 1 for 15-20 days and then switch to Level 2.Thinner skin (between eyebrows (the 11 lines), crows feet, etc.) Great alternative for Botox.

If you are seeing a solid conductive bar, that means that there are currentsconducting across your skin. The conductivity bar will flashing means you are not conducting. Make sure you are using a good amount of gel primer and you are hydrated.

Blinking - you are not conducting. Either you didn’t apply enough gel, the gel has dried, or the spheres are not completely touching the skin.

- Are you on Level 2-Erase and working on “thinner” skin? Switch to Level 1 and do eyes, crows feet and above/under lip and see if the conductivity stops blinking. If it does, go ahead and switch back to Level 2 and finish your treatment.

- Dehydrated - if the gel is drying quickly you are most likely dehydrated. This will contribute to the conductivity bar blinking. Spray some RePlenish Spritzer on before putting on the gel. Then if the gel gets tacky, just spray some Replenish Spritzer to reactivate the gel.

- Change the angle of the sphere.

Stays Solid - With the unit on, test the applicator by slightly touching the two applicator metallic parts together. If the conductivity bar still doesn’t turn solid, then there is an issue with the applicator and we will send a replacement.

Please feel free to pull the wires to the probes apart as much as you like.

You want to use Educate level 1 on the neck, forehead and under the eyes. The reason is because it’s an area on the face that the skin is thin. There are some instances when a person may have a thicker neck and you will be able to use Educate level 2. Your conductivity bar will let you know by whether it stays solid or blinks.

There is not enough skin on the forehead and it will be more of a glide in that area. You are still working on the frontalis muscle. What Mode Do I Use For Surface Wrinkles? Erase mode can be used on surface lines/wrinkles on the face and neck. The movements are quicker, and should be made the opposite way of the wrinkle. If the wrinkle is horizontal you are going to do your movements vertically.

Erase mode can be used on surface lines/wrinkles on the face and neck. The movements are quicker, and should be made the opposite way of the wrinkle. If the wrinkle is horizontal you are going to do your movements vertically.

Level 1 works the surface muscles and level 2 is for the deeper muscles. You can work on level 2 to start with someone who has looser skin, but not on the forehead, under the eyes, and neck (unless the neck is thicker).

Yes, if there is an area of concern, or maybe lots of loose skin or deep wrinkles it’s o.k. to spend more time on those areas. It’s also ok to hold the pinch longer on areas if it’s a problem area for the client.

We recommend starting with Erase to relax or lengthen the muscles, and then use the Educate to shorten or tighten the muscles.

The Myolift Mini and Myolift 600 device are safe and gentle enough for everyday use, either morning or night. We recommend using Myolift or Myolift 600 devices every other day, for 5-20 minutes per treatment. For the first 60 days we recommend using MyoLift Mini or MyoLift 600 1-3 times a week. Then monthly/bi-monthly for maintenance.

Each one is a difference frequency (wave pattern). The waveforms are the “key” that tell the muscle whether you want to lengthen or shorten.

We do not recommend using it close to the heart. We were FDA cleared to only use this device on the facial muscles.

Conductivity gel helps to reduce the resistance of the skin so the microcurrent can reach the area you want to work on. Our special, dual-action conductive treatment gels are the industry’s first conductive gels with purpose! 7E is the first company to synergize the science of microcurrent machines and technology with the health and well-being of the skin through active products and result oriented treatments! We formulated three unique conductive treatment gels for specific skin types. This creation has bridged the gap in treating the muscles and treating the skin simultaneously with microcurrent therapy. There is something for everyone when it comes to our line of gels. Read more here!

Yes, we recommend you take a picture of your client before the treatment and only do one half of the face. Then your client will be able to see the difference. Remember microcurrent results can be subtle. It also depends on the age, skin condition, hydration, poor diet, medication, stress. There are many factors as to how fast your client will respond to the treatment. Remember this treatment is cumulative so focus on the areas that you are seeing results in. Help your client to understand you’re not able to give them a result that a surgical face lift can, but help them to be realistic about what microcurrent can do. Have before/after photos available for them to see.

You will use the gloves the same way you use the probes. You are still able to do Educate and Erase. You will want to wear latex, vinyl or nitrile gloves under the conductivity gloves so all of the current goes to your clients and not to your hands

To Clean: You can wash the gloves with an antibacterial soap and air dry. Do not use caustic cleaners (ie: barbicide or quats). Read our blog on how to clean your gloves here!

This is a safety feature; the MyoLift Mini or MyoLift 600 will not turn on when plugged into a wall for charging. Your MyoLift Mini and MyoLift 600 comes pre-charged right out of the box and will last for many uses. Only plug into the wall for charging needs.

No, we are FDA cleared for the face only.

You can purchase more gel by visiting our website or clicking here!

Yes. The tips are separated as one negative and the other positive, but you don’t need to worry which one is which; they just need to be used together.

No. You cannot use one probe on one side and the other probe on the other side. They both need to be close together on each area of the face.

Non-invasiveProgressive not aggressiveAnti-aging benefits without down timeResults are cumulativePerformed in a series for optimal resultsFDA-cleared over-the-counter microcurrent deviceUnique design helps accurate and consistent delivery of micro currentPortable and lightweight with rechargeable battery system

We do have a conductive gel for sensitive skin. You can purchase it here on our website. It is called ReNu Conductive Gel.

The battery indicator on the screen shows how much charge is left. If the charge is lessthan half, you will need to recharge the unit. If you see the unit is not turning on (nothing will be visible on the LCD), then you definitely will want to recharge the unit.

Microcurrent targets unwanted bacteria and acne scarring. Plus, it's effective in treating acne as it destroys the bacteria, while encouraging the healing process without harming healthy skin.

The battery will last at least 8 hours.

It will take about 2-3 hours. You may want to charge it on an overnight basis.

We offer free, online monthly webinars for the Myolift. Please contact us for more information. We also have a closed Facebook page open to all licensed estheticians who own one of our devices. We post training events, all videos, and great feedback from our wonderful group of estheticians. Read more about all 7E Wellness education and support here!

Microcurrent technology should be slower movements. You will get a better result if you slow down.